Does the Mr. Mister work with any auger motor?

Was this article helpful? Vote!
No votes
The Mr.Mister can be retrofitted to most drive motors but it is a direct bolt on for the Mr. Manhole drive motors. The main components are the spray head which bolts directly to the Premier Model 40 - 2 1/2" or 2" hex drive motor & the Digga 2 1/2" 5DDS-11-MM via a special hardware kit that is shipped with the Mr. Mister along with detailed mounting instructions.

Resource Link: https://mrmanhole.com/product/mr-mister-silica-control/
Additional Link: https://www.youtube.com/watch?v=tFY2jCGzz1A&t=10s

Related Articles

Tightening the speedplate in the manhole - unlock, tighten, release all those videos together

Pull out the retaining knob and turn it a quarter of a turn to lock it out. Now take the adjusting wheel and spin it in by hand. You're going to use the wrench now, and you're going to use it in a spe

View

Intro to adjusting for center in manhole frame

The first stage of adjusting to the center of the main hall frame is to pull these adjusting pins. Following that, you're going to grab here, and then you're going to pick up and move this to the cent

View

Using the Lifting Magnet

View

Replacing the Guideshaft Lift Pin

View

Comments