What are the wear parts on the Mr. Manhole cutter?

Was this article helpful? Vote!
No votes
The teeth and the blades are the primary ground engaging parts. The arms could eventually get a little worn and need replaced but it would be rare and take many many thousands of cuts. The rest of the cutter is pretty bulletproof. The Speedplate will need the rubber dampers replaced on a regular basis and the wearblock can wear after a few hundred cuts. The drive motor can require Maintenance occasionally.

Additional Link: https://mrmanhole.com/product/carbide-tooth-and-roll-pin/

Related Articles

Tightening the speedplate in the manhole - unlock, tighten, release all those videos together

Pull out the retaining knob and turn it a quarter of a turn to lock it out. Now take the adjusting wheel and spin it in by hand. You're going to use the wrench now, and you're going to use it in a spe

View

Intro to adjusting for center in manhole frame

The first stage of adjusting to the center of the main hall frame is to pull these adjusting pins. Following that, you're going to grab here, and then you're going to pick up and move this to the cent

View

Using the Lifting Magnet

View

Replacing the Guideshaft Lift Pin

View

Comments